rc-aircraft-workshop-edurade

ABOUT RC AIRCRAFT

Your first step into the world of UAV

A radio-controlled aircraft also referred to as RC aircraft or RC plane, is a small flying machine that is controlled remotely by an operator on the ground using a hand-held radio transmitter. Most common RC Aircraft types can be scale, semi-scale and non-scale models. These three terms refer to the reality of the model; whether it replicates a real aircraft (scale), is a close representation of a real aircraft (semi-scale) or is a completely made-up design (non-scale). Scaled RC Aircrafts are extensively used in modern aviation industry and defense sector to determine and validate the original aircraft designs.

The basic RC Aircraft types are trainer airplanes, sport airplanes, aerobatic airplanes, warbirds, vintage RC airplanes, RC float planes.



2500
HOURS TRAINED
1000
HAPPY STUDENTS
30
RECOGNITIONS

WORKSHOP OUTCOME

DESIGN

Know the principles behind RC aircraft design, fundamentals of aerodynamics & various components of RC Aircraft

ELECTRONICS

Introduction to electrical components (brushless motors, servo motors, ESC and installation principles on a RC Aircraft

FABRICATE

Learn hands-on methods of scratch building a RC Aircraft, integrating electronics into it and making it ready to fly

FLY

Learn about different flying techniques of RC Aircrafts, understand the error in design (if any) which hindered a good flight

WORKSHOP HIGHLIGHTS

The RC aircraft workshop of Edurade makes the participants walk through the science of flying objects by making them design and fabricate their own RC Aircrafts. Scratch building a RC Aircraft rather than building it from a commercial kit, kitbashing or buying it pre-assembled helps participants understand the concepts of aerodynamics, flight dynamics,aero-structures and avionics involved in aircraft design in an application oriented manner. This RC Aircraft Design aeromodelling workshop is delivered through the below mentioned sessions.

SESSIONS AT A GLANCE

Design Session

  • Lecture on fundamentals of aerodynamics

  • Understand various components of an aircraft

  • Know about stability and control of an aircraft

  • Design algorithm of a RC Aircraft

Software Session

  • Selection of Aerofoils in a RC Aircraft

  • Wind tunnel analysis of the selected aerofoil

  • Wing design based upon aerofoil

  • Analysis of wing performance and aircraft stability

Electronics Session

  • Know about the electronic components

  • Brushless Motors, ESC, Servo Motors among others

  • LIPO Battery and their specified requirements

  • Functionalities of Transmitter & Receiver

Fabrication Session

  • Hands-on experience in building a RC Aircraft

  • Get trained in installing the electronic components

  • CG balancing & stability check

  • Making the RC Aircraft ready to fly

Flying Session

  • Get on-field flight lessons from our RC Pilot

  • Range test of the RC Transmitter

  • Fabrication faults that hindered a good flight

  • Best RC Aircraft Design selection


Note:The parts marked* are not parts of economy kit. These components would be provided during the RC Aircraft workshop (per team) but would be taken back after the workshop. This is being done to reduce the cost of the RC Aircraft workshop and make it affordable for students who do not want to buy the complete kit.

Attend any of our upcoming workshops. Join Now

Why Edurade

  • Certifications

    Globally valid certificates under Global Accreditation Board

  • Mentoring

    One-to-one sessions with mentors to bridge conceptual knowledge gap

  • Pedagogy

    Application oriented sessions to help in practically implementing the theoretical concepts

  • Agility

    We’re just a call away from attending your queries

  • Trainers

    Each trainer having 200+ hours of experience in training

  • Evaluations

    Online evaluation test after workshop to ascertain maximum knowledge gain